Lamp Systems; Sentinel Headlamp Delay Module Removal And Installation; Daytime Running Lamp Module Removal And Installation - Jeep Cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION
SENTINEL HEADLAMP DELAY MODULE . . . . . . . 19
REMOVAL AND INSTALLATION
SENTINEL HEADLAMP DELAY MODULE
REMOVAL
(1) Remove the knee blocker.
(2) Remove the screw that attaches the module to
the inside of the instrument panel (Fig. 1).
(3) Disconnect the wire harness connector and
remove the module from the instrument panel.
Fig. 1 Headlamp Delay Module
1 – BRACKET
2 – HEADLAMP DELAY MODULE
INSTALLATION
(1) Position the module inside the I/P and connect
the wire harness connector to the module.
(2) Install the screw that attaches the module to
the inside of the instrument panel.
(3) Install the knee blocker.

LAMP SYSTEMS

TABLE OF CONTENTS
page
DAYTIME RUNNING LAMP MODULE . . . . . . . . . . 19
DAYTIME RUNNING LAMP MODULE
REMOVAL
The Daytime Running Lights (DRL) module is
located on the right fender inner panel adjacent to
the dash panel (Fig. 2).
1 – DAYTIME RUNNING LIGHT MODULE
(1) Disconnect the wire harness connector from the
module.
(2) Remove the screws that attach the module to
the fender inner panel.
(3) Remove the module from the fender inner
panel.
INSTALLATION
(1) Position the module on the right fender inner
panel.
(2) Install the attaching screws. Tighten the
screws securely.
(3) Connect the wire harness connector to the mod-
ule.
Fig. 2 Daytime Running Lamp Module
LAMPS 8L - 19
page