8L - 4
LAMPS
ADJUSTMENTS (Continued)
1 – CENTER OF VEHICLE
2 – CENTER OF HEADLAMPS
3 – 15° CUT-OFF LINE
4 – FRONT OF HEADLAMP
Fig. 2 Headlamp Beam Adustment Screws
1 – LEFT/RIGHT ADJUSTMENT SCREW
2 – UP/DOWN ADJUSTMENT SCREW
3 – HEADLAMP
Fig. 1 Headlamp Alignment Screen—Typical
5 – 10 METERS (32.8 ft.)
6 – HORIZONTAL CUT-OFF LINE
7 – 130mm
FOG LAMP ALIGNMENT
Prepare an alignment screen. Refer to the Align-
ment Screen Preparation paragraph in this section. A
properly aligned fog lamp will project a pattern on
the alignment screen 200 mm (8 in.) below the fog
lamp centerline and straight ahead (Fig. 3). To
improve visual interpretation of the fog lamp pattern
on the alignment screen, disable the headlamps by
disengaging the wire connectors from the headlamp
bulbs.
To adjust fog lamp alignment, rotate alignment
screws (Fig. 4) to achieve the specified pattern.
XJ