Power Mirror Removal And Installation - Jeep Cherokee 2000 Service Manual

8T - 4 POWER MIRROR SYSTEMS
REMOVAL AND INSTALLATION (Continued)
POWER MIRROR TEST
12 VOLTS GROUND
PIN 1
PIN 4
PIN 2
PIN 3
PIN 5
Fig. 3 Power Mirror Test
Fig. 4 Stand-Alone Power Mirror Switch Remove/
1 – STAND-ALONE POWER MIRROR SWITCH
2 – CONNECTOR
3 – DOOR TRIM PANEL
(4) Lift the front door trim panel upwards and
away from the inner door panel far enough to disen-
MIRROR
REACTION
PIN 4 UP
PIN 1 DOWN
PIN 3 LEFT
PIN 2 RIGHT
PIN 6 HEATER
Install
Fig. 5 Front Door Trim Panel Remove/Install
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
gage the top of the panel from the inner belt weath-
erstrip.
(5) Pull the front door trim panel away from the
inner door panel far enough to access the inside door
latch release and lock linkage rods near the back of
the inside door remote controls.
(6) Unsnap the plastic retainer clips from the
inside door remote control ends of the latch release
and lock linkage rods, and remove the rod ends from
the inside door remote controls.
(7) Unplug the wire harness connectors from the
door module.
(8) Remove the trim panel from the front door.
(9) Remove the three screws that secure the door
module to the front door trim panel (Fig. 6).
(10) Remove the door module from the front door
trim panel.
(11) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
POWER MIRROR
(1) Disconnect and isolate the battery negative
cable.
(2) If the vehicle is so equipped, remove the man-
ual window regulator crank handle with a removal
tool (Fig. 7).
(3) Remove the screws that secure the front door
trim panel to the inner door panel (Fig. 8) or (Fig. 9).
(4) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the front door trim panel
away from the door around the perimeter to release
the trim panel retainers.
XJ