Stop Lamp Switch; Servo Cable - Jeep Wrangler 1999 Electronic Service Manual

TJ
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Speed Control Switch Remove/Install
(5) Connect negative battery cable to battery.

STOP LAMP SWITCH

Refer to Stop Lamp Switch in Group 5, Brakes for
removal/installation and adjustment procedures.

SERVO CABLE

REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Using finger pressure only, remove cable con-
nector by pushing connector off the throttle body
bellcrank pin (Fig. 5). DO NOT try to pull cable
connector off perpendicular to the bellcrank
pin. Connector will be broken.
(3) Two squeeze tabs are located on sides of speed
control cable at cable locking plate (Fig. 6). Squeeze
the tabs together and push cable out of cable locking
plate.
(4) Unclip cable from cable guide at valve cover
(Fig. 6).
(5) Disconnect servo cable at servo. Refer to Speed
Control Servo—Removal/Installation.
INSTALLATION
(1) Attach end of cable to speed control servo.
Refer to Speed Control Servo Removal/Installation.
(2) Install cable into cable locking plate (snaps in).
(3) Install cable
bellcrank pin (snaps on).
(4) Clip cable to cable guide at valve cover.
(5) Connect negative battery cable to battery.
(6) Before starting engine, operate accelerator
pedal to check for any binding.
connector at throttle
Fig. 5 Servo Cable to Bellcrank—Remove/Install
body
Fig. 6 Squeeze Tabs at Cable Locking Plate
SPEED CONTROL SYSTEM 8H - 5