Hoist; Correct Vehicle Lifting Locations - Jeep Cherokee 2000 Service Manual

Hide thumbs Also See for Cherokee 2000:

Table of Contents

LUBRICATION AND MAINTENANCE

SERVICE PROCEDURES (Continued)

Fig. 3 Correct Vehicle Lifting Locations

1 – SUB-FRAME RAIL LOCATION

2 – SUB-FRAME RAIL LOCATION

CAUTION: Do not attempt to lift a Jeep vehicle with

a floor jack positioned under:

• An axle tube.

• A body side sill.

• A steering linkage component.

• A drive shaft.

• The engine or transmission oil pan.

• The fuel tank.

• A front suspension arm.

NOTE: Use the correct sub-frame rail or frame rail

lifting locations only.

HOIST

A vehicle can be lifted with:

• A single-post, frame-contact hoist.

• A twin-post, chassis hoist.

• A ramp-type, drive-on hoist.

NOTE: When a frame-contact type hoist is used,

verify that the lifting pads are positioned properly.

WARNING: THE HOISTING AND JACK LIFTING

POINTS PROVIDED ARE FOR A COMPLETE VEHI-

CLE. WHEN A CHASSIS OR DRIVETRAIN COMPO-

NENT IS REMOVED FROM A VEHICLE, THE

CENTER OF GRAVITY IS ALTERED MAKING SOME

HOISTING CONDITIONS UNSTABLE. PROPERLY

SUPPORT OR SECURE VEHICLE TO HOISTING

DEVICE WHEN THESE CONDITIONS EXIST.