Percentage Weighing - Adam Equipment Eclipse EBL Series Operating Manual

EN
10.4.2

Percentage Weighing

Percent weighing will be done by defining a certain weight to be 100%. The weight to be
used can either be entered by the user or taken from a sample
Press [Mode] and then the [Up] or [Down] key until "
percent weighing mode by pressing [Select].
Display will show, "SAmmPLE
Press the [Up] or [Down] keys to toggle between the two methods and press [Select] to
select the desired method.
10.4.2.1 Sample method:
%
SAmmPLE
When "SAmmPLE SAmmPLE SAmmPLE " is displayed, press [Select].
LOAd LOAd LOAd LOAd
%
When " 100 100 100 100 " is shown, carefully add the sample to the pan. Now press [Select] to set
this weight to be 100%. The display will show "REF
selected unit. After a short pause, "100
Remove the sample and "0 0 0 0 .00
Now place an unknown sample on the pan to display the percentage weight relative to the
original sample. Press [Print] to output result to a connected device if required.
To set another weight as 100%, press [Mode] and repeat as before, or to return to normal
weighing mode, press [Mode] followed by [
10.4.2.2 Manual method:
To manually enter a value to be set as 100%, when "Ent
[Select]. The display will show "100
in the weighing mode.
Change the displayed weight to the required sample weight using the direction keys and
numeric entry method and press [Select] to enter the value. The display will now return to
zero.
Now place unknown samples on the pan to display the percentage weight relative to the
set sample weight. Press [Print] to output result to a connected device if required.
To repeat percent weighing with another sample press [Mode] and continue as before, or
to return to normal weighing mode, press [Mode] followed by [
NOTE: The [Up] and/or [Down] keys are lit. Percentage will be initially displayed to the
maximum number of decimal places based on the resolution of the balance. To increase
or decrease by one decimal place each time, press the [Up] or [Down] key respectively.
The [Print] key is lit, indicating that print output to a connected device is available. Print
output will be in the form "XX.XX %" matching the number of decimal places selected on
screen.
© Adam Equipment Company 2015
%
SAmmPLE SAmmPLE SAmmPLE " (sample method) or "Ent
100.00 100 100
%
00 00 00 " will be displayed
100 W W W W Wt Wt = = = =" followed by a weight value in the unit last used
100 100 Wt Wt
PERCENT PERCENT
PERCENT PERCENT
Ent W W W W Wt Ent Ent Wt Wt Wt
REF REF REF WT WT" and the sample weight in the last WT WT
%
00 00 00 " will be displayed.
0/T].
Ent W W W W Wt
Ent Ent
23
3016612482 Rev1-Aug15
"is displayed. Now enter
%
" (manual weight method).
%
Wt
Wt Wt " is displayed, press
0/T].