Format Of Custom Forms #1 And #2 - Adam Equipment Eclipse EBL Series Operating Manual

EN
The parameters that can be set are:
On
EnAbLE EnAbLE EnAbLE EnAbLE
OFF = serial port disabled
bAvd bAvd bAvd bAvd Set Baud Rate. Selectable values: 4800
PARITY PARITY Set Parity. Selectable values: nO
PARITY PARITY
ON = print only when reading is stable
STABLE STABLE
STABLE STABLE
OFF = print regardless of stability
ON = Send data continuously over serial port
CONTIN CONTIN
CONTIN CONTIN
OFF = Only send data when [PRINT] is pressed
ON = Set the RS-232 to send data periodically. Range 1 to 999 seconds
PErIOd PErIOd PErIOd PErIOd
OFF = No periodic data transmission
Format of serial output data. Selectable parameter from:
FORMAT FORMAT FORMAT FORMAT
SINGLE
STANDARD = Serial data output sent in standard format
FORM 1
FORM 2

13.4 FORMAT OF CUSTOM FORMS #1 and #2

If FORM1 or FORM2 is selected, the format be changed by the user using a selection of
available data. By default the 2 forms are the same as the standard form unless changed
by the user as below.
When "FORMM1 FORMM1" or "FORMM 2
FORMM1 FORMM1
each line of the form. Pressing the [Up] or [Down] keys will cycle through the options
available. The options are:
Instrument ID number
INST ID INST ID INST ID INST ID
Serial Number
SER No SER No
SER No SER No
Time
TIME E E E TIM
TIM TIM
Date
DATE DATE DATE DATE
Net Weight (Gross weight – Tare Weight)
NET NET NET NET
Gross Weight
GROSS GROSS GROSS GROSS
Tare Weight
TARE TARE
TARE TARE
Unit weight in parts counting mode
vNiT vNiT
vNiT vNiT
Number of items in parts counting mode
CoVNT CoV CoV CoV NT NT NT
100% weight in percent weighing mode
REF REF REF REF
Percentage of reference weight in percent weighing
PER PER PER PER
Low Limit when check weighing (Not used)
LO LIM LO LIM
LO LIM LO LIM
High Limit when check weighing (Not used)
HI LIM HI LIM
HI LIM HI LIM
Inserts a blank line
CR LF CR LF CR LF CR LF
Signifies the end of the report
END END END END
(When END is entered the display returns to the SERIAL
Enter the data to be printed on the first line by pressing [Up] or [Down] to cycle through
the options. If the current information is OK then press [Select] to move to the next line.
e.g. "LINE 01 LINE 01 LINE 01 LINE 01", "DATE DATE" – will print date on first line of output form. DATE DATE
© Adam Equipment Company 2015
= serial port enabled
= Serial data output sent as a single line
= Serial data output sent in custom-designed format FORM 1
= or FORM 2
FORMM 2" is selected, the user can set the information to be printed on
FORMM 2 FORMM 2
4800 4800, 9600 4800 9600, 19200 9600 9600 19200 19200 or 38400 19200
nOnE nE, EVEN EVEN or ODD ODD
nO nO nE nE EVEN EVEN ODD ODD
(See section 13.4).
39
3016612482 Rev1-Aug15
38400 38400 38400
SERIAL Sub-menu) SERIAL SERIAL