Table of Contents
Advertisement
Upgrading software using the Web interface
This section describes how to upgrade the device software through the Web user
interface (Web UI). This upgrade procedure assumes that the BSGX4e unit is
installed into a working IP network as described in
Requirements
To upgrade the BSGX4e software using the web UI, you must have the following:
A workstation on which you can run one of these Internet browsers: Microsoft
Internet Explorer or Mozilla FireFox.
The IP address of the BSGX4e. If you connect from the WAN, use the eth0 address.
If you connect from the LAN, use the eth1 address. The procedure for showing the
IP address is described under
The logon name and password for a user account that has administrator
capabilities, such as the default account nnadmin.
The location of the file containing the upgrade software. The file must be on the
workstation; its location is entered during the upgrade procedure. Select the file
from the workstation directories with the Browse button.
Note: To acquire the upgrade software, contact
Logging on to the Web user interface
1. Start the Web browser on the workstation.
2. On the entry line of the Web browser, enter the IP address of the BSGX4e unit.
If the workstation is connected through the LAN, enter the eth1 address; if the
workstation is connected through the WAN, enter the eth0 address:
For example, assuming that the eth1 IP address has not be changed from its
default, enter the following to log on from a workstation on the LAN:
n
n
3. The logon window opens and requests a user name and password:
BSGX4e Business Gateway Installation Guide
Release 01.01
HTTP:
http://192.168.1.1
HTTPS:
https://192.168.1.1
Installation (page
IP Address/Mask for eth0 (page
"How to get help" on page
15).
23).
11.
32
NN47928-303
Advertisement
Table of Contents
