Connecting The Cables; Bsgx4E Back Panel - Avaya BSGX4e Installation Manual

After the BSGX4e is physically installed into the network, network connections are
initialized. If a Dynamic Host Configuration Protocol (DHCP) service is working
properly on the WAN, the BSGX4e receives its IP addressing information from the
DHCP server. This process occurs automatically as soon as the BSGX4e is connected
to the WAN.
However, if DHCP service is not available or not working properly, you can enter IP
addressing information manually. At a minimum, you need to enter the IP address
for the eth0 WAN interface, the default gateway address, and the Domain Name
System (DNS) server address.
information.
After the WAN network connection is established, you can configure other ports and
servers at the console or through a remote connection to the BSGX4e through the
WAN or from a workstation in the LAN. For complete configuration information, see
the BSGX4e Business Gateway User Guide on the Documentation CD.
Table 5. Network Information
Network Destination
BSGX4e WAN interface
(eth0)
Default gateway
Primary DNS server
(DNS1)
DNS domain name
(optional)

Connecting the cables

This section describes how to physically connect the BSGX4e unit.
Figure 4. BSGX4e Back Panel
BSGX4e Business Gateway Installation Guide
Release 01.01
Table 5 includes blank spaces to record this minimum
IP Address / Subnet Mask
WAN Port LAN Ports
12V DC
POWER
18
NN47928-303