Quick Setup Guide, Rear Connection For Plasma - Everlast PowerUltra 206Pi Setup And User Manual

Section 2
QUICK SETUP GUIDE: REAR CONNECTIONS FOR PLASMA OPERATION
3
1
2
4
NOTE: A SEPARATE AIR DRYER BETWEEN THE AIR COMPRESSOR AND REGULATOR ASSEMBLY MUST BE INSTALLED. IT SHOULD BE INSTALLED
AS CLOSE TO THE UNIT AS PRACTICAL. THIS IS A CUSTOMER SUPPLIED ITEM. THIS WILL REDUCE CUTTING ISSUES SUCH AS SPITTING, POPPING
AND RAPID CONSUMABLE WEAR. THE REGULATOR/FILTER THAT IS INCLUDED IS NOT SUFFICIENT TO REMOVE ALL MOISTURE. IT SERVES ONLY
AS A WATER TRAP AND FINE SEDIMENT FILTER. ANY AIR COMPRESSOR SYSTEM PRODUCES MOISTURE IN ALMOST ANY ENVIRONMENT REGARD-
LESS OF HUMIDITY LEVELS IN THE ATMOSPHERE. DAILY DRAINING OF THE AIR COMPRESSOR IS RECOMMENDED AS WELL FOR BEST RESULTS.
THE AIR SUPPLIED TO THE PLASMA CUTTER SHOULD BE OF SIMILAR QUALITY USED FOR AUTOMOTIVE PAINTING. DIFFERENT STYLES OF DRYERS
ARE AVAILABLE. THE MOST INEXPENSIVE AND COMMONLY AVAILABLE IS THE REPLACEABLE DESSICANT TYPE USED FOR AUTOMOTIVE PAINT-
ING. DAMAGE DONE TO THE TORCH AND THE PLASMA CUTTER (INCLUDING BUT NOT LIMITED TO: SHORTING, CORROSION AND DETERIORA-
TION OF INTERNAL LINES AND COMPONENTS) AS A RESULT OF EXCESS MOISTURE IS NOT COVERED UNDER WARRANTY. ADDITIONALLY, A FILTER
SHOULD BE INSTALLED IN-LINE NEAR THE COMPRESSOR. THAT WILL FILTER ANY EXCESS OIL OR OIL BLOW-BY FROM THE LINE IF NECESSARY. DO
NOT USE WITH AN OILING SYSTEM DESIGNED TO AUTOMATICALLY LUBRICATE AIR TOOLS. IT IS ADVISABLE TO USE THE PLASMA CUTTER WITH A
NEW AIR HOSE/LINE THAT IS FRESH WITHOUT MOISTURE OR LUBE CONTAMINATION. IF THE AIR PRESSURE DROPS FROM THE COMPRESSOR TO
THE CUTTER MORE THAN 5-10 PSI, OR AIR FLOW IS INSUFFICENT, INCREASE TO A LARGER SIZE DRYER/FILTER OR AIR HOSE. FAILURE TO USE THE
PROPER DRYER/FILTER IS THE NUMBER ONE CAUSE OF CUTTING ISSUES.
Compressor and Dryer Diagram
Compressor and Air hose w fittings
(Customer Supplied)
1/4" Automotive Universal style
quick connector (Included)
Air Dryer/Oil Filter
(Customer Supplied)
NOTE: WHEN ASSEMBLING AIR REGULATOR NOTICE THE MARKING S THAT
ARE STAMPED ON TOP OF THE REGULATOR HOUSING FOR AIR FLOW DIREC-
TION. AIR FLOW DIRECTION WILL BE NOTED AS IN/OUT OR BE STAMPED WITH
A SMALL ARROW FOR AIR FLOW DIRECTION. THE QUICK CONNECT 1/4" MALE
AUTOMOTIVE COUPLING SHOULD BE MOUNTED ON THE SIDE OF THE REGU-
LATOR WITH "IN" OR THE ARROW POINTING TO THE MIDDLE OF THE REGULA-
TOR. ALSO THE BRASS PLUG INCLUDED WITH THE ACCESSORY PACKAGE
SHOULD BE MOUNTED IN THE CENTER HOLE.
15
QUICK SETUP AND USE GUIDE
Regulator Assembly with
built-in water trap
and dirt filter (Included)
1~220 V
GAS
INLET
Connect for Plasma Use Only.