Everlast PowerUltra 206Pi Setup And User Manual page 27

Section 3
TIP: For longer consumable life do not use the pilot arc unnecessarily. Rapid wear will oc-
cur if the pilot arc stays engaged more than 3 seconds at a time.
FLAME AT NORMAL TRAVEL SPEED
NOTE: When stepping down amps to cut thinner material, or using on 120V, you
must change to smaller orifice nozzle for the best cutting results. Too large of an ori-
fice diameter will result in arc instability and a rough cut. Lowering the air pressure
below 60 psi to try to get the torch to cut will only result in a lazy, wandering arc or an
arc that sputters on and off continuously.
IMPORTANT: Check consumables regularly for wear and change them out before
they are completely worn. Allowing the consumables to wear until they quit working
may damage related torch components, creating a more costly repair.
TRAVEL
FLAME AT SLOW TRAVEL SPEED
Basic theory and function
FLAME AT FAST TRAVEL SPEED
TRAVEL
27
TRAVEL