Unit Specifications - Everlast PowerUltra 206Pi Setup And User Manual

Section 1
FEATURE/SPECIFICATION
INVERTER TYPE
INPUT VOLTAGE ±10%;PHASE/FREQUENCY
MAXIMUM INPUT AMPS (I₁MAX), Inrush.
MAXIMUM INPUT RUNNING AMPS (I₁eff), Rated.
DUTY CYCLE % @ AMPS
OUTPUT RANGE : AMPS/VOLTS
OPEN CIRCUIT VOLTAGE
TIG TORCH
PLASMA TORCH
CONSTANT CURRENT (CC) OUTPUT TYPE
STICK CELLULOSE ELECTRODE CAPABILITY 6010,6011
INCLUDES
DINSE CONNECTOR TYPE
POST FLOW
PROTECTION CLASS
INSULATION GRADE
*This unit is DC output only. Practically speaking, AC TIG is required to weld aluminum . In some circumstances,
DC TIG can be used to weld aluminum, but it is not a practical solution to TIG welding aluminum. This unit is not
designed or sold to provide a suitable choice for welding aluminum with TIG. However, the plasma cutter may be
used to cut aluminum, Keep in mind, due to the metallurgical properties of aluminum, cut capacities are diminished
when cutting aluminum by 30%. Also, in stick mode, with a special aluminum electrodes, some aluminum welding
may be accomplished, but it has practical limitations due to the expensive nature of aluminum ellectrodes and skill
required to do so. Aluminum stick electrodes donot provide an acceptable solution to aluminum production weld-
ing, especially on metal thinner than 1/8" and should only be used for emergency repairs on thicker materials, after
testing the method for suitability.
POWERULTRA 206Pi INPUT/OUTPUT SPECIFICATIONS
POWERULTRA 206Pi
IGBT, Digitally controlled
120/240V; 1PH/50-60Hz
30A @ 120V/ 28A @ 240V
19A @ 120V/ 18A @ 240V
TIG:
Plasma: [120V] 35%@25A/90V
Stick:
TIG: [120V] 5-125A/10.2-15V [240V] 5-200A/10.2-18V
Stick: [120V] 5-100A/20.2-24V [240V] 5-160A/20.2-26.4V
Plasma: [120V] 20-25A/88-90V [240V] 20-50A/88-100V
TIG: 70 V
STICK: 70V
PLASMA: 250 V
26 SERIES (standard type)
S-45 type (Blow back, non high frequency start)
DC (±) *
6011 is permissible (DC+). No 6010 capability. The unit works well and
is designed for use most other types of electrodes.
WORK CLAMP WITH CABLE (8 FT),STICK TORCH WITH CABLE (8FT), TIG
TORCH: 12 FT, PLASMA S-45 12 FT, CONSUMABLE STARTER KIT FOR
TIG AND PLASMA (NO TUNGSTEN)
25 Series for both positive and negative connectors
ADJUSTABLE 0-50 Seconds
IP21S
F
Introduction and Specifications
[120V] 60% @125A/15V 100%@ 100A/14V
[240V] 60%@200A/18V 100%@160A/16.4V
60%@22A/88.8V
[240V] 35%@50A/100V 60%@40A/96V
[120V] 35%@100A/24V 60%@80A/23.2V
[240V] 35%@160A/26.4V 60%@130A/25.2V 100%@100A/24V
10
100%@20A/88V
100%@ 30A/92V
100%@60A/22.4V