Lenovo x3250 m6 Installation And Service Manual page 137

Figure 57. Operating temperature enhancement kit removal
Step 6. Complete the parts replacement. See "Completing the parts replacement" on page 172.
Installing the operating temperature enhancement kit
To install the operating temperature enhancement kit, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See "Removing the server cover" on page 88.
Step 3. Remove the PCI riser-card assembly. See "Removing the PCI riser-card assembly" on page 93.
Step 4. Connect the operating temperature enhancement kit connector to the system board.
Step 5. Route the cable along the chassis. Make sure the relevant cables pass through the cable clips.
Figure 58. Operating temperature enhancement kit cable connection for 2.5-inch-drive model
.
Chapter 7 Removing and installing server components
123