Lenovo x3250 m6 Installation And Service Manual page 130

Step 5. Connect one end of the cable to the connector on the RAID adapter. Make sure the relevant cables
pass through the cable clips and no cables cover or obstruct the battery holder.
Figure 48. RAID adapter battery or flash power module cable connection
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct
any components on the system board.
Step 6. Connect the other end of the cable to the battery or flash power module. Then, remove the retainer
and open the retention clip of the battery or module holder.
116
Lenovo System x3250 M6 Installation and Service Guide