Section 12-Electronics; Removing/Installing The Joystick; Removing; Installing - Pronto M61 Owner's Operator And Maintenance Manual

SECTION 12—ELECTRONICS
SECTION 12—ELECTRONICS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Removing/Installing the Joystick

NOTE: For this procedure, refer to FIGURE 12.1.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.
2. Cut the tie-wraps that secure the joystick cable to the arm.
3. Loosen the adjustment lock lever to release the joystick mounting tube from the
mounting bracket. Refer to FIGURE 12.1.
4. Remove the joystick and joystick mounting tube from the mounting bracket.

Installing

1. Slide joystick mounting tube through the mounting bracket to the desired position.
2. Tighten the adjustment lock lever to secure the joystick mounting tube to the
mounting bracket on the other arm.
3. Tie-wrap the joystick cable to the arm as shown in FIGURE 12.1.
4. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.
Pronto® M61™with SureStep®
WARNING
72
Part No. 1139640