Engaging/Disengaging Motor Release Lever - Pronto M61 Owner's Operator And Maintenance Manual

2. Place the top shroud on the base frame and push downward to engage the hook and
loop straps.
3. Secure the joystick cable using the clip on the top shroud.
4. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 40.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.
Clip
Center
Hole in
Top
Shroud
Joystick Cable
and Connector
Base
Frame
Hook and
Loop
Strap

Engaging/Disengaging Motor Release Lever

DO NOT engage or disengage the motor release lever until the On/Off switch on
the joystick is in the Off position.
Ensure both motor release levers are fully engaged before driving the wheelchair
NOTE: For this procedure, refer to FIGURE 10.2.
NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled
operation. Freewheeling allows an attendant to maneuver the wheelchair without power.
1. Locate the motor release handles on the motors protruding through the top shroud on
the rear of the wheelchair.
2. Perform one of the following:
• To Disengage the Motor Release Levers - Pull the motor lock lever towards the rear
of the wheelchair (freewheel position).
Part No. 1139640
FIGURE 10.1 Removing/Installing the Top Shroud
WARNING
CAUTION
SECTION 10—TOP SHROUD AND WHEELS
Top
Shroud
Hook and
Loop Strap
Front
Shroud
NOTE: Batteries not
shown for clarity.
59
Pronto® M61™with SureStep®