Adjusting The Footboard Assembly; Angle - Pronto M61 Owner's Operator And Maintenance Manual

2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls of the quick release pin are fully released beyond the outer edge
of the tube (Detail "A" of FIGURE 8.1).
Mounting Hole
Quick
Release Pin
FIGURE 8.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle

NOTE: For this procedure, refer to FIGURE 8.2.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
FIGURE 8.2 Adjusting the Footboard Assembly - Angle
Part No. 1139640
Top Shroud
Pinch Point
Footboard
Assembly
Detent
Ball
Set Screw, Washer
and Jam Nut
49
SECTION 8—FOOTBOARD ASSEMBLY
DETAIL "A" - BOTTOM VIEW OF
FOOTBOARD
Quick Release Pin
Outer Edge
of Tube
Footboard
Assembly
Pronto® M61™with SureStep®
Detent Balls