Adjusting Seat Position On Seat Base - Pronto M61 Owner's Operator And Maintenance Manual

*NOTE: 9 cm mounting screws shown. 4 cm and 6 cm mounting screws are supplied
with the seat.

Adjusting Seat Position on Seat Base

Refer to the table in FIGURE 7.6 for proper seat post mounting positions. For users
over 100 kg - seat MUST be in the 3 cm back position (FIGURE 7.6) when using seat
post mounting holes 3, 4 and 5 (FIGURE 7.6). Refer to Adjusting the Seat Height on
page 42.
NOTE: For this procedure, refer to FIGURE 7.6.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 40.
2. Remove the four mounting screws and washers securing the seat adapter plate to the
seat base (FIGURE 7.6).
3. Separate the seat adapter plate from the seat base.
4. Refer to FIGURE 7.6 to determine the correct mounting holes to achieve the desired
seat position.
5. Align the mounting holes on the seat adapter plate (determined in STEP 4) with the
mounting holes on the seat base.
Part No. 1139640
Seat
Base
3 cm
Adjustment
Spacers
Seat Adapter
Plate
Mounting
Screws*
FIGURE 7.5 Adjusting the Seat Height
WARNING
43
SECTION 7—SEAT
3 cm
Adjustment
Spacers
Washers
Pronto® M61™with SureStep®