Installing Seat Angle Bracket For 5° Tilt - Pronto M61 Owner's Operator And Maintenance Manual

Installing Seat Angle Bracket for 5° Tilt
NOTE: For this procedure, refer to FIGURE 7.6 and FIGURE 7.7.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 40.
2. Remove the four mounting screws and washers securing the seat adapter plate to the
seat base.
3. Align the mounting holes on the seat angle bracket with the mounting holes on the
seat base (Detail "A" of FIGURE 7.7).
4. Using the four 3 cm mounting screws and washers from the seat angle bracket kit,
secure the seat angle bracket to the seat base (Detail "A" of FIGURE 7.7).
5. Determine the correct mounting holes on the flanges on the seat angle bracket to
achieve the proper seat position (Detail "C" of FIGURE 7.7).
NOTE: The seat position mounting holes on the flanges on the seat angle bracket correspond to the
seat position mounting holes on the seat base. Refer to FIGURE 7.6 for the proper seat positions.
6. Perform one of the following:
A. Without Height Adjustment Spacers - If height adjustment spacers are not to be
used, use the four 3 cm mounting screws, washers, and locknuts from the seat
angle bracket kit to secure the seat adapter plate to the flanges on the seat angle
bracket (Detail "B").
B. With Height Adjustment Spacers - If height adjustment spacers are to be used, use
the four 5 cm mounting screws, washers, and locknuts from the spacer hardware
kit to secure the spacers and the seat adapter plate to the flanges on the seat angle
bracket (Detail "B"). The spacers are installed between the seat angle bracket and
the seat adapter plate.
NOTE: Only one set of spacers (total of two spacers) can be installed when the seat angle
bracket is installed.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 40.
Part No. 1139640
45
SECTION 7—SEAT
Pronto® M61™with SureStep®