Removing Front Rigging Bracket - Pronto M61 Owner's Operator And Maintenance Manual

SECTION 9—FRONT RIGGINGS
4. Determine the correct mounting holes to achieve the desired front rigging bracket
position (Detail "B").
5. If necessary, remove up to four mounting screws located under the seat that secure the
seat back brackets in place (Detail "B").
6. Slide the front rigging bracket forward or backward to the desired position.
7. Tighten the three mounting screws on each side of the front rigging bracket that were
loosened in STEP 3 (Detail "A").
8. Using the applicable mounting holes, secure the front rigging bracket to the seat back
brackets with the mounting screws which were removed in STEP 5 (Detail "B").
9. Install the two hangers in the bracket tube and slide them to the desired positions.
10. Securely tighten the four hanger mounting screws that were loosened in STEP 2
(Detail "A").
11. Install the seat. Refer to Removing/Installing the Seat Assembly on page 40.

Removing Front Rigging Bracket

1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 40.
2. Loosen the four hanger mounting screws and remove the two hangers (Detail "A").
3. If necessary, remove up to four mounting screws located under the seat that secure the
front rigging bracket to the seat back brackets (Detail "B").
4. Remove the three mounting screws and six washers on each side of the front rigging
bracket which attach the bracket to the seat base (Detail "A").
5. Remove the front rigging bracket.
6. Using the applicable mounting holes in the seat back brackets, install the mounting
screws which were removed in STEP 3. Refer to Adjusting Seat Depth on page 41.
7. Install the seat. Refer to Removing/Installing the Seat Assembly on page 40.
Pronto® M61™with SureStep®
52
Part No. 1139640