Using The Proper Batteries; Removing/Installing Batteries From/Into Battery Tray - Pronto M61 Owner's Operator And Maintenance Manual

SECTION 11—BATTERIES

Using the Proper Batteries

NOTE: For this procedure, refer to FIGURE 11.1.
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery
(FIGURE 11.1).
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the correct position of the POSITIVE and
NEGATIVE terminals (FIGURE 11.1).
Batteries with terminal configuration as shown below MUST be used. Batteries that
have the reverse terminal configuration MUST NOT be used - otherwise injury and
damage may occur.
Use This Configuration
U1 Battery

Removing/Installing Batteries from/into Battery Tray

Always use the battery handle when lifting the battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
Pronto® M61™with SureStep®
WARNING
NEGATIVE (-)
Battery Terminal
NEGATIVE (-)
Battery Terminal
POSITIVE (+)
Battery Terminal
FIGURE 11.1 Using the Proper Batteries
WARNING
DO NOT Use
64
POSITIVE (+)
Battery Terminal
U1 Battery
Part No. 1139640