Disconnecting Battery Cables; Charging Batteries - Pronto M61 Owner's Operator And Maintenance Manual

Disconnecting Battery Cables

The use of rubber gloves is recommended when working with batteries.
NEVER allow any of your tools and/or battery cables to contact both battery termi-
nals at the same time. An electrical short may occur and serious personal injury or
damage may occur.
NOTE: For this procedure, refer to FIGURE 11.3.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 40.
2. Remove the batteries. Refer to Removing/Installing Batteries from/into Battery Tray
on page 64.
3. Cut the tie-wrap that secures the battery terminal cap in place (Detail "B" of
FIGURE 11.3).
4. Slide terminal caps up onto the battery cables (FIGURE 11.3).
5. Disconnect POSITIVE (+) battery cable from the POSITIVE (+) battery terminal
(FIGURE 11.3).
6. Disconnect NEGATIVE (-) battery cable from NEGATIVE (-) battery terminal
(FIGURE 11.3).

Charging Batteries

NEVER attempt to recharge the batteries by attaching cables directly to the
battery terminals.
DO NOT attempt to recharge the batteries and operate the wheelchair at the same
time.
DO NOT attempt to recharge the batteries when the wheelchair has been exposed
to any type of moisture.
DO NOT attempt to recharge the batteries when the wheelchair is outside.
DO NOT sit in the wheelchair while recharging the batteries.
DO NOT attempt to recharge the batteries using both the on-board battery
charger and an independent battery charger (plugged into the joystick charger
port) at the same time. Doing so will reduce the life of the batteries.
Read and carefully follow the individual instructions for each charger (supplied or
purchased). If charging instructions are not supplied, consult a qualified technician
for proper procedures.
Part No. 1139640
WARNING
WARNING
69
SECTION 11—BATTERIES
Pronto® M61™with SureStep®