Adjusting Legrest Angle; Setting Legrest End Stop - Pronto M61 Owner's Operator And Maintenance Manual

Adjusting Legrest Angle

WARNING
Before driving the wheelchair, ensure
there is adequate clearance between
the legrests and the front casters and/or
the ground. Incorrect adjustment of the
legrests may cause bodily injury.
NOTE: For this procedure, refer to
FIGURE 9.3.
1. Pull up the release handle.
2. Adjust the legrest up or down to the
desired angle.
3. Push down the release handle to secure
the legrest into position.

Setting Legrest End Stop

NOTE: For this procedure, refer to FIGURE 9.4.
NOTE: This procedure requires a 1 x 10 mm open-ended wrench.
1. Refer to Adjusting Legrest Angle on page 55 to swivel the legrest upward in order to
access the rubber stop.
2. Use the open-ended wrench to loosen the counternut.
3. The rubber stop can be screwed in or out or pushed up or down the legrest adjusting
tube. Move the rubber stop to the desired position.
4. Re-tighten the counternut.
5. Refer to Adjusting Legrest Angle on page 55 to move the legrest to the desired
position.
Part No. 1139640
FIGURE 9.4 Setting Legrest End Stop
55
SECTION 9—FRONT RIGGINGS
FIGURE 9.3 Adjusting Legrest Angle
Rubber Stop
Counternut
Legrest Adjusting Tube
Pronto® M61™with SureStep®
Release
Handle
Legrest