Brother ADS-2400N User Manual page 226

Scan Using the Control Panel
Setting Description
Contrast Adjust the setting (from -50 to 50) to get the best image.
The default value of 0 represents an average and is
usually suitable for most images. You can increase or
decrease the contrast level by moving the slider to the
right or left. An increase emphasises dark and light areas
of the image, while a decrease reveals more details in
grey areas. You can also enter a value in the box to set the
Contrast.
NOTE
The Contrast setting is available only when setting
Scan Type to Auto, Grey (Error Diffusion),
True Grey or 24bit Colour.
Default Restore all settings to their factory default values.
Carrier Sheet Scan the following documents using the Carrier Sheet.
Mode For this mode, you can select any setting other than Auto
from the Document Size drop-down list.
 Large-sized Documents (A3, B4 and Ledger)
Fold the document in half and insert it in the Carrier
Sheet for 2-sided (duplex) scanning, then both front
and back pages are combined into a single page.
Select 2 in 1(A4) for an A3 document, 2 in 1(B5) for a
B4 document or 2 in 1(Letter) for a Ledger document
from the Document Size drop-down list.
 Important documents (photos, contracts)
 Thin paper (receipts)
 Irregularly-shaped paper (clippings)
NOTE
• Load only one Carrier Sheet at a time.
• Set the document in the centre of the Carrier Sheet and
align the top of the document with the top of the Carrier
Sheet.
Applicable Feature
Image OCR E-mail
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
File
Yes
Yes
7
Yes
211