Enabling Remote Access - Avaya 3500 Quick Start Configuration

Variable
[no]
<dest-ip>
<mask>
<next-hop>
[<cost>]
[enable]
[disable]
[weight<cost>]

Enabling remote access

You can enable remote access for telnet, SSH (on SSH software images), SNMP, and webpage
access.
For more information, see Using ACLI and EDM on Avaya Ethernet Routing Switch 3500 Series,
NN47203-102 and Configuring Systems on Avaya Ethernet Routing Switch 3500 Series, NN47203–
506.
About this task
Use the following procedure to enable and configure remote access to the management features of
the switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable telnet remote access, enter the following command:
September 2016
Value
Removes the specified static route.
Specifies the destination IP address for the route
being added.
DEFAULT:
0.0.0.0 is considered the default route.
Specifies the destination subnet mask for the route
being added.
Specifies the next hop IP address for the route being
added.
Specifies the weight, or cost, of the route being
added.
RANGE:
1–65535
Enables the specified static route.
Disables the specified static route.
Changes the weight, or cost, of an existing static
route.
RANGE:
1–65535
Quick Start Configuration
Comments on this document? infodev@avaya.com
Enabling remote access
33