Displaying The Current Banner - Avaya 3500 Quick Start Configuration

enable
configure terminal
2. At the command prompt, enter the following command:
[no] banner [custom | static | disabled | <1–19> LINE ]
Variable definitions
The following table describes the parameters for the banner command.
Variable
static
custom
disabled
<1–19> LINE
no

Displaying the current banner

Display the current banner.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show banner [custom | static]
Variable definitions
The following table describes the parameters for the show banner command.
Variable
static
custom
(if empty)
September 2016
Value
Displays the default agent-banner
Displays the custom agent-banner
Skips the agent-banner display
Fills the Nth line of the custom banner (1<N<19) with
the text specified in LINE
Clears all lines of a previously stored custom banner
Value
Displays default banner
Displays custom banner
Displays static, custom or disabled status if
parameter is not entered
Quick Start Configuration
Comments on this document? infodev@avaya.com
Customizing the opening banner
27