Avaya 3500 Quick Start Configuration page 39

Use the definitions in the following table to use the snmp-server location command.
Table 3: snmp-server location command
Variable
<text>
Use the definitions in the following table to use the snmp-server host command.
Table 4: snmp-server host command
Variable
<host-ip>
<community-string>
September 2016
Definition
Specify the SNMP system location value. Enter an
alphanumeric string of up to 255 characters.
Definition
Specify an IPv4 or IPv6 address for a host intended
to be the trap destination.
If you are using the proprietary method for SNMP,
enter a community string that works as a password
and permits access to the SNMP protocol.
Quick Start Configuration
Comments on this document? infodev@avaya.com
Configuring system identification
39