Displaying The Local Time Zone Settings - Avaya 3500 Quick Start Configuration

end: 3rd week of September on Saturday at 23:57
Offset: 60 minutes.
Variable definitions
The following table describes the parameters for the summer-time recurring command.
Variable
<1–5>
<DAY>
<MONTH>
<hh:mm>
<1–1440>

Displaying the local time zone settings

Display the settings for the local time zone.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show clock time-zone
Example
The following figure provides a sample of the output of the show clock time-zone command.
switch(config)#show clock time-zone
Time zone offset from UTC is 00:00
September 2016
Value
Specifies the week of the month. The first
occurrence specifies when the recurring starts, and
the second specifies when the recurring stops.
Specifies the day of the week as the first 3 letters of
the name. The first occurrence specifies when the
recurring starts, and the second specifies when the
recurring stops.
Specifies the Month using the first 3 letters of the
name. The first occurrence specifies when the
recurring starts, and the second specifies when the
recurring stops.
Specifies the time in hours and minutes in military
format (24–hr). The first occurrence specifies when
the recurring starts, and the second specifies when
the recurring stops.
Specifies the number of minutes to add or subtract
during summer-time recurring.
Quick Start Configuration
Comments on this document? infodev@avaya.com
Displaying the local time zone settings
31