Vega VEGABAR 66 Operating Instructions Manual page 68

10 Supplement
Result of table plausibility check
-
"0: ""Uninitialized"" 1: ""Good"" 2: ""Not monotonous increasing"" 3: ""Not monotonous
-
decreasing"" 4: ""Not enough values transmitted"" 5: ""Too many values transmitted"" 6:
""Gradient of edge too high"" 7: ""Values not excepted"" 8: ""Table currently loaded"" 9: ""Sorting
and checking table"""
SUB_DEVICE_NUMBER
l
SENSOR_ELEMENT_TYPE
l
0: "non-specific"
-
display_source_selector
l
Selects the type of value that is displayed on the indication-/adjustement-module
-
"0: ""Physical value"" 1: ""Percent value"" 2: ""Lin percent value"" 6: ""Out(AI1)"" 7: ""Level"" 8:
-
""Out(AI2)"" 9: ""Out(AI3)"""
max_peak_sensor_value
l
Holds the maximum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
Write access resets to current value
-
min_peak_sensor_value
l
Holds the minimum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
Write access resets to current value
-
CAL_POINT_HI
l
Highest calibrated value. For calibration of the high limit point you give the high measurement
-
value (pressure) to the sensor and transfer this point as HIGH to the transmitter. Unit derives from
'Sensor_range.unit'
CAL_POINT_LO
l
Lowest calibrated value. For calibration of the low limit point you give the low measurement value
-
(pressure) to the sensor and transfer this point as LOW to the transmitter. Unit derives from
'Sensor_range.unit'
CAL_MIN_SPAN
l
Minimum calibration span value allowed. Necessary to ensure that when calibration is done, the
-
two calibrated points (high and low) are not too close together. Unit derives from 'Sensor_range.
unit'
SCALE_IN
l
Min/max-adjustment: Upper and lower calibrated points of the sensor. Unit derives from
-
'Sensor_range.unit'
trimmed_value
l
Sensor value after the trim processing. Unit derives from 'Sensor_range.unit'
-
sensor_sn
l
Sensor serial number
-
temperature
l
Process temperature. Selected as input to AIFB by setting 'Channel' = 4. Unit derives from
-
'Temperature.unit'
temperature_unit
l
Unit code of 'Temperature', 'Max/Min_peak_temperature_value'
-
°C, °F, K, °R
-
68 VEGABAR 66 • Foundation Fieldbus