Exerpeutic 1317.5-101016 Owner's Manual page 17

ASSEMBLY
Tool:
5mm Allen Wrench
1PC
Step 5
Assemble Handlebar.
Use the 5mm Allen Wrench to remove two Hexagon Socket Head Bolts (32), two Spring
Washers (80), and two Curve Washers (38) from the Front Post (4).
Attach the Handlebar (5) to the Front Post (4) using the previously removed hardware: two
Hexagon Socket Head Bolts (32), two Spring Washers (80), and two Curved Washers (38).
Tighten the bolts using the 5mm Allen Wrench until they are firm and secure.
There will be another set of Hand Pulse Sensor Wires (17) coming out from the Handlebar (5)
Connect that set to the other set of Hand Pulse Sensor Wires (17) coming from the console as
shown in Figure AA-3.
Slide the Wire Plug (89) over the Hand Pulse Sensor Wires (17) and carefully tuck the excess
Hand Pulse Sensor Wires (17) and Wire Plug (89) into the right side of the Front Post (4).
15