Exerpeutic 1317.5-101016 Owner's Manual page 16

ASSEMBLY
Tool:
5mm Allen Wrench
1PC
MUST TIGHTEN IN SEQUENCE: A,B,C,D,E,F,G,H.
Step 4
Assembly of Front Post.
Use the 5mm Allen Wrench to remove eight Hexagon Socket Head Bolts (109), eight Spring
Washers (80), and eight Curve Washers (38) from the Front Post (4). Put these hardware aside.
Thread the Tension Control Knob Cable (116) cable coming out from under Main Post (4) into
the cable lock end of the Tension Cable (14). See Figure A. Once the Tension Control Knob
Cable (116) is in place, give it a good tug upwards into the slot of the metal bracket of the Tension
Cable (14). See Figure B . Remove the Clip (120) from the cable lock end of the Tension Cable
(14). Figure C. If threaded correctly, the connection should look like Figure D.
Connect the Console Extension Wire (12) from the Front Post (4) with the Extension Sensor
Wire (15) from the Main Frame (1).
Insert the Front Post (4) into the Main Frame (1). Reinstall the previously removed hardware: eight
Hexagon Socket Head Bolts (109), eight Spring Washers (80), and eight Curve Washers (38)
and securely tighten the bolts using the 5mm Allen Wrench provided.
14