Install the judder spring
ATTENTION : There is a sense.
Install the special friction disc.
Install all the metal and friction discs.
Reinstall the clutch release bearing assembly,
the clutch spring holder in the reverse order of
their removal.
Torque the clutch screws to: 10Nm
Install the clutch cover dowels, a new clutch
cover gasket and tighten to 10Nm.
DISASSEMBLING THE LEFT SIDE
For additional details refer to the parts catalog
250 SEF-R and 300 SEF-R.
Disassembling the ignition case
Drain the engine oil.
Remove the 10 screws that retain the ignition
case.
Visually inspect the inner surfaces of the rotor
[A] and the outer surfaces of the stator [B].
Check the pulse generator (sensor)
Replace if necessary.
Replacing the stator and sensor
system
Remove the 2 screws that retain the sensor
[C] and the 2 screws that retain the stator [D].
Install the new parts.
Reinstall the screws using the proper torque
with strong Loctite (red)
Do not forget the AET washers below the
stator screws.
Torque the stator and sensor screws to:
8Nm.
25