SHERCO 250 SEF-R Workshop Manual page 46

 The following window opens. Click
« Finish »
The installation is complete.
B- Connect one end of the "MUXDIAG II" interface cable to a USB port on your computer.
Connect the other end to the diagnostic connector on the motorcycle.
Check to make sure that the "MUXDIAG II" is receiving power. The LED lights should be lit:
 Solid blue: The PC connection has been successfully established
 Flashing blue: Connected to current PC
 Blue LED off: The PC is off or in standby mode or there is a problem with the USB
connection
 Steady green: There is a problem with the software
 Flashing green (slow): The software is functioning correctly
 Flashing green (fast): Connected to current PC
 Green off: The firmware is not present
 Solid red: The card is receiving power
All LED's off : The unit is not plugged in, it is in standby mode or there is a USB problem
45