Install the wrist pin into the piston and
connecting rod using the tool and lightly
tapping with a hammer.
Install the opposite circlip, using the special
tool.
Install the cylinder over the piston using an
appropriate ring compressor.
Install the two cylinder head locating pins
[A].
Install the head gasket [B].
Install the cylinder head.
Install the head bolts noting the different
lengths; tighten them using two passes in
the order shown in the photo.
Install and tighten the two M6 nuts.
Cylinder head torque:
st
Studs
1
pass: 30 Nm
nd
2
pass: 45 Nm
Nuts M6: 10 Nm
ATTENTION : The two internal bolts are of
different length and are equipped with
washers.
18