On the right hand case make sure the
breather jet is in place.
Place the right case on the left case
previously fabricated.
Install the 13 screws that retain the two
halves together.
Torque the 13 center crankcase screws
to: 10 Nm.
Install special tool number 2073 to keep the
gear selector drum from rotating.
Install the locating pin, the gear selector
index wheel and the fixing screw.
Torque the gear selector index wheel
fixing screw to: 10 Nm.
Remove the special tool number 2073.
Install the gear selector shaft.
Install the oil pump shaft, the roll pin and the
internal oil pump rotor.
Install the oil pump cover and tighten the
cover screws to the appropriate torque.
Torque the oil pump cover screws to: 5
Nm.
Install the oil pump drive roll pin, the drive
gear and the cir clip.
Install the primary drive gear.
On the transmission input shaft install the
thrust washer, the needle bearings the clutch
basket, the spacer washer, the clutch hub
and the conical washer.
Using an appropriate solvent clean the
crankshaft threads and the input shaft
threads.
Install the fixing nuts on the crankshaft and
the transmission input shaft.
Apply the proper torque these fixing nuts.
Install special tool number 1817 and torque
the crankshaft fixing nut.
Torque the crankshaft fixing nut to: 120
Nm.
With the special tool still installed, torque the
transmission input fixing nut.
Torque the transmission input fixing nut
to: 80 Nm.
33