Install the camshaft retaining cover. (pay
careful attention to the tightening order).
Camshaft retaining cover torque
10Nm
ATTENTION : The screw n°1 is a M6 X 35
Install the camshaft chain tensioner using
a new gasket.
Torque the two fixing bolts to:
10Nm
Install the cam tensioner adjusting bolt
(pay attention to the o-ring).
Torque the tensioner adjusting screw
to: 10Nm
Remove the special tool number 1819.
Rotate the engine a few times to make
sure that the valve timing is correct.
Finally check the valve timing using the
timing marks.
Replace the cap that was removed to
install tool number 1819.
Torque the cap to:
8Nm
Replace the spark plug well.
ATTENTION : Make sure that the o-rings
are installed on the spark plug well.
Apply a thin coat of silicone to the
camshaft end cap bores.
Replace the valve cover.
Install the valve cover installation bolts.
Torque the bolts to:
8Nm
20