Reassembling
crankcase assembly
ATTENTION : During the rebuild, replace all
seals (paper, seal, o-ring...).
Install the crankshaft and counter balancer
assembly in the left case, align the marks as
shown.
Install the transmission gear along with their
corresponding shafts.
Install a new roller on each shift fork.
Install the shift forks in the transmission in
their respective grooves.
Install the gear selector drum.
Place the shift fork rollers in their respective
grooves in the drum.
Install the shift fork shafts
ATTENTION : The center shift fork shaft is
the smallest in diameter.
ATTENTION : Do not forget to lubricate all of
the rotating and sliding parts.
Replace the two locating dowels in the case
and install the washer on the transmission
secondary shaft.
the
central
32