Software Presentation; Connection With Keyless System - SHERCO 250 SEF-R Workshop Manual

SOFTWARE PRESENTATION

2.1-

Connection with Keyless system

Sherco had a Keyless system on its motorcycles which allows the bike to switch on without any
key and switch off automatically after 30secondes of non-use.
This last point blocks the diagnostic, this is why it is necessary to follow the steps down below
before doing it.
1. Remove the plug (1) from the connector (2) (located on the rear sub frame – on the right
part of the bike).
2
2. Take the shunt (3) (reference 6267) and connect the plug (1) into it.
3
3. You can now do the diagnostic by following the next explanations.
1
2
1
46