Install the special tool that locks the engine
at top dead center (ref 1819).
Use tool 1817 to block the transmission ant
to tighten balancer nut.
Torque
of
balancer
threadlocker.
Install the oil pump drive roll pin, the intern
rotor and fixing nut to the cover.
Torque of the oil pump cover : 5 Nm.
Heat the crankshaft spacer ring (ref 1732) to
approximately 70 degrees and install it on
the crankshaft.
Replace the freewheel assembly and the
starter drive gear train (see the paragraph on
disassembling the left side).
Reinstall the starter.
Reinstall the motor top end (see the
paragraph on the top end).
Install the cam drive chain (see the
paragraph on top end).
Install the clutch (see the paragraph on
disassembling the right side).
Install the clutch cover.
Install the spark plug.
Torque the spark plug to: 15 Nm.
ATTENTION : Apply threadlocker to all of
the internal engine threads except the five
clutch pressure plate fixing screws.
nut
60
Nm
+
34