Console Description - Matrix T3xe Owner's Manual

MANAGER MODE AND ENGINEERING MODE
T1X AND T3X CONSOLES:
These sections allow users to manipulate default settings for the machines. It may be accessed by pressing the Incline
Down/Speed Down keys simultaneously for 5 seconds. To change a setting, press "Enter" on the keypad under 'Manager
Mode' or 'Engineering Mode' and use the incline or speed buttons and numeric keypad to enter a category and change the
values. Pressing "Enter" again will save the change. Pressing "Back" will bring you to the previous menu. To exit Manager or
Engineering Mode, hold "Pause" down for 5 seconds. Below is a list of the settings that can be changed for the T3x.
MANAGER MODE SETTINGS:
Maximum Time Accumulated Time
Default Time Software Version
Default Level Start Speed
Default Age Maximum Speed
Default Weight Speed Mode
Accumulated Distance Out of Order
HRT Speed Based
TREAD SENSE BASIC FUNCTION
The treadmill software will stop If no footfalls or user interactions with the console are measured, a warning message
the belt if no footfalls are detected will display on the console. A 10 second countdown will begin and the belt will stop,
or if no buttons are pressed on ending the program.
the console. Engages when
The default stop time can be set at 30, 60 or 90 seconds and be turned off completely in
speed is over 0.5 mph (0.8 kph).
manager mode. Service technicians can also disable the feature in engineering mode.
40
MX15_T1x_T1xe_T3x_T3xe_OM_Rev2_0.indd 40-41
ENGINEERING MODE SETTINGS:
Gender Disable Error Reset Default
Language Elevation Minimum Club ID
Sound Mode Elevation Maximum Audio Source
Navy Test Site Auto Calibration Volume Control
Tread Sense Speed Units AM System
Pause Time ErP Time
Serial Number
T1XE, T3XH AND T3XE CONSOLES:
These sections allow users to manipulate default settings for the machines. Manager Mode may be accessed by pressing
ENTER, 1, 0, 0, 1, Enter on the keypad. Engineering Mode may be accessed by pressing ENTER, 2, 0, 0, 1, Enter on the
keypad. The screen shots on the next page show what you will see when you enter Manager Mode and Engineering Mode.
This console has a fully integrated touch screen display. Lightly touch the screen and use the intuitive interface to adjust
the settings. Any and all changes made will be saved when the "home" button is touched in the upper left-hand corner of
the screen. Touching the "home" button will exit manager or engineering mode and return you to the main screen. It is not
necessary to touch this button after each setting is changed.

CONSOLE DESCRIPTION:

The Matrix machine is inspected before it is packaged. It is shipped in two pieces: the base and the console. Carefully
unpack the unit and dispose of the box material.
41
5/22/15 1:49 PM