Overlay Description And Custom Setting; Console Description; Engineering Mode; Manager Screen Description/Details - Matrix T3x Series Owner's Manual

3.1 CONSOLE DESCRIPTION

QUICK-KEYS
PROGRAM KEYS Simple program view and selection buttons. Six programs to choose from
QUICK START/START One touch Start and Quick Start
SELECT To confirm each program setting
STOP Press the STOP key once to pause the program for 2 minutes. During the 2 minute
pause, press the QUICK START key to continue running the program, or else the machine will
reset automatically. Also, you can press and hold the STOP key to reset the treadmill.
UP/DOWN ELEVATION Easy information and elevation selection.
UP/DOWN SPEED Easy information and speed selection.
EMERGENCY STOP To stop all functions running
SPEED KEYS - NUMBERS Press the Speed Keys' numbers to input program Time, Weight,
and Target Heart Rate
SPEED KEYS - RESET To cancel the numbers entered by the Speed Keys numbers
SPEED KEYS - ENTER To confirm each program setting
3.0 O

3.2 ENGINEERING MODE

Engineering screens allow the viewing and editing of variables that would be necessary for
a club operator/manager to customize. Unless otherwise noted engineering screens consist
of the initial screen, the editing or action screen and the saving screen. The initial screen
displays the variable type and in most cases the current value. Edit or action screens are
where the editing of the variable(s) take place. The saving screen indicates the variable(s)
is being saved.
To access the Engineering screens press and hold the ELEVATION 'UP' and SPEED 'PLUS'
buttons for three seconds. The display will now display 'Engineering Mode'.
Use the ELEVATION UP or DOWN arrows to scroll through the different engineering
screens.
Press SELECT to edit the selected engineering screen.
Use the SPEED UP or DOWN arrows to set the variable.
SPEED KEY
Press START to save the selected variable.
3.3 MANAGER SCREENS EXCEPTIONS/DETAILS
Below is a list of functions for each engineering screen. Exceptions will be noted in the
description for each engineering screens:
LOW SPEED LEARN MODE (EDIT)
P0
This variable controls the low limit for the speed of the treadmill.
P1 HIGH SPEED LEARN MODE (EDIT)
This variable controls the high limit for the speed of the treadmill.
P2 MIDDLE SPEED LEARN MODE (EDIT)
This variable controls the middle limit for the speed of the treadmill.
4
D
VERLAY ESCRIPTION AND
C S
USTOM ETTINGS