Matrix T3xe Owner's Manual page 11

ASSEMBLY STEP 1
T3
xh
20
MX15_T1x_T1xe_T3x_T3xe_OM_Rev2_0.indd 20-21
Cut the yellow banding straps and lift the
A
running deck upward to remove all contents
from underneath the running deck.
B Remove the motor cover and set aside. The
motor cover needs to be removed to gain
access to the motor compartment so that wire
harness connections can occur.
Z11
Z12
NOTE: Do not tighten bolts until step 4 is complete.
ASSEMBLY STEP 2
BLUE HARDWARE BAG CONTENTS :
Z12
Z11
FLAT WASHER
SOCKET HEAD CAP SCREW
Qty: 8
Qty: 8
Z11
Z12
Open BLUE HARDWARE BAG.
A
Assemble both the left and right console
B
masts to the treadmill base using 4 SOCKET
HEAD CAP SCREWS (Z11) and 4
FLAT WASHERS (Z12).
NOTE: The console mast caps are marked with
an L if they are to be used on the left-hand side
of the treadmill or an R if they are to be used on
the right-hand side of the treadmill. If the console
mast caps are assembled on the incorrect side of
the treadmill, the unit will not assemble correctly.
5/22/15 1:49 PM
T3
xh
21