Reset Power; Clean Primex Eco Clock - Primex XR series Installation Manual

Reset Power

Use this procedure if you need to completely power down and restart the clock. Since the Primex Eco Clock contains both
a rechargeable battery and a backup battery, you must remove the jumper in order to fully remove power from the
circuitry.
1. Remove the clock from its location so that you can access the back of the clock. For additional information, see
"Remove the Primex Eco Clock" located on page 9.
2. Remove the CR123 backup battery.
3. Remove the jumper located on the two rightmost pins of the connector. For additional information, see "Start the
Primex Eco Clock" located on page 7.
4. Wait one minute.
5. Reinstall the jumper on the two rightmost pins.
6. Reinstall the CR123 backup battery. For additional information, see "Replace Backup Battery" located on page 10.
NOTE: Insert the battery '+' end to '+' end of the battery holder to achieve proper battery orientation.
The clock will turn on the radio receiver and the second hand will advance one step every 5 seconds until time signal is
received (Model 14149 only). Once the time signal is received, the hands will advance rapidly until the clock reaches the
correct time broadcast by the transmitter. If light conditions are adequate, the clock will operate normally.

Clean Primex Eco Clock

Clean the Primex Eco Clock by wiping it down with commonly used disinfectants or water.
WARNING: Immersion or spraying of the clock may cause permanent damage.
Primex Wireless
XR Series Eco Clock Installation Guide
11