Configuring Dhcp Relay Agent (Dynamic Addressing) - Paradyne 8540 User Manual

Configuring DHCP Relay Agent (dynamic addressing)

8000-A2-GB20-20
Use this procedure to provide dynamic Service Domain IP address allocation to
the end-user systems attached to the DSL RTUs.
Procedure
To configure relay agent:
1. Make certain that the Gateway address used in relaying DHCP requests is
configured as an e1a address (A-C-B).
2. Select Configuration
3. Enter values for the following field and press Return after each entry:
Field
Domain Names
NOTE:
Unless your client supports the domain names field, you will not be able
to have service selection. By default, each port can be assigned one
service provider.
The Interface IP address is read only and is required to key in the
corresponding domain name.
4. Select Configuration
5. Enter values for the following field and press Return after each entry:
Field
DHCP Server
Authen Server (optional)
RADIUS Secret
(optional)
Authen Type
Authentication Wait TIme
(optional)
Number of Authentication
attempts
Dynamic access control
security
Port (1–4) Default DHCP
Domain Index
November 1997
Configuring the HotWire DSLAM
DHCP Relay Domain Names (A-G-A) .
Description
ISP domain names.
DHCP Relay Servers 1–8 or 9–16 (A-G-B or C) .
Description
DHCP server IP address.
Authentication server IP
address for this domain.
RADIUS encryption value.
Type of authentication you
want performed.
Authentication time out.
Authentication attempts.
Security control flag.
Which domain's DHCP
service will be used.
Input
32 maximum characters.
Input
nnn.nnn.nnn.nnn format.
nnn.nnn.nnn.nnn format.
Up to 16 numeric
characters.
N = none (No
authentication to be
performed.)
R = RADIUS (Forward a
message to a RADIUS
server.)
T = XTACACS (Forward a
message to a XTACACS
server.)
Default = 5 seconds.
Default = 2 seconds.
E = Enable
D = Disable.
0 = no default.
4-17