Configuring Static Routes To End Users On Each Dsl Card - Paradyne 8540 User Manual

Configuring the HotWire DSLAM

Configuring Static Routes to End Users on each DSL Card

4-16
Use this procedure to enable the management traffic from the 8546 DSL cards to
the 5446 RTU and attached end-user systems. Use SNMP or the IP Injection Tool
to download the needed enterprise MIBs and to configure static routes and
service domain routes to end users attached to each 5446 RTU. Refer to
Appendix F, 5446 RTU Setup.
NOTE:
Each time you create a static route for an end-user system behind an RTU,
you should also create a corresponding source-based input filter rule. See
Chapter 5, IP Address Allocation, Chapter 6 , IP Routing, and Chapter 7,
IP Filtering , of the HotWire DSLAM for 8540 and 8546 DSL Cards Network
Configuration Guide .
Procedure
To configure a static route to End Users:
1. Select Configuration
2. Press Return on the Item 0 field to add a new record.
3. Enter values for the following fields and press Return after each entry:
Field
Host/Net
Subnet Mask
Next Hop (on Model
8546)
Next Hop (on Model
8540)
Pref (Preference)
S/D (Source/Destination)
PA (Proxy ARP)
4. Confirm the save and press Ctrl-z to return to the Configuration
menu.
November 1997
IP Router Static_Routes (A-E-A) .
Description
Destination of the route.
Associated subnet mask
for the specified
destination IP address.
IP address of the next hop
device for the specified
destination.
DSL port name for next
hop.
Measure of how preferable
one route is to another, if
you have two routes going
to the same destination.
Source or destination route
type.
Router answers ARP
requests intended for
another machine.
Input
0.0.0.0 to indicate the
default route
nnn.nnn.nnn.nnn format
On Model 8540, subnet
mask must be
255.255.255.255.
nnn.nnn.nnn.nnn format
Port name s1c, s1d, s1e,
or s1f.
The lower the number, the
more preferable the route.
Default = Dst
Default = No
IP Router
8000-A2-GB20-20