Paradyne 8540 User Manual page 116

Monitoring the HotWire DSLAM
7-28
Table 7-9. Network Protocol Options (7 of 7)
PPP Stats (General)
Displays a summary of the PPP activity on a selected interface on the card.
Interface Name – Enter the name of the desired DSLinterface (s1c, s1d, s1e, s1f).
Link Phase – Current phase/state of this link (Init, Link Control).
Octets Transmitted – Number of octets (8 bit bytes) transmitted.
Frames Transmitted – Number of frames (groups of data bits) transmitted.
Octets Received – Number of octets received.
Frames received – Number of frames received.
Alloc failures on send – Number of packets not transmitted because there was no
memory available to build the packet.
Unknown Pkts Received – Packet with unknown received.
Bad Checksum Packets Received – Packet with a bad checksum received.
Frame Errors Received – Packet received with bad framing.
Other Pkt Errors Received– Packet received with an error not listed above.
Alloc failures Received – Card was unable to allocate enough memory to receive the
packet.
LCP Stats (PPP)
Displays a summary of the Link Control Protocol (LCP) activity on a selected interface
on the card. The screen is divided into two parts – the left side is for the local end of the
link; the right half is for the remote end of the link.
Interface name – Enter the name of the desired interface (s1c, s1d, s1e, s1f).
Link Phase – Current phase/state of this link (Init, Link Control, Opened).
Async Bit Map – Coding used to embed PPP control characters in the data section of
the packet.
Authentication – Authentication type required for the connect to be accepted (usually
none).
Magic number – Unique number associated with this end of the link, used to ensure the
link is not a loopback.
IPCP General Stats (PPP)
Displays a summary of the IP Control Protocol (IPCP) activity on a selected interface on
the card. The screen is divided into two parts – the left side is for the local end of the
link; the right half is for the remote end of the link.
Interface name – Enter the name of the desired interface (s1c, s1d, s1e, s1f).
Link Phase – Current phase/state of this link (Init, Link Control, Opened).
LCP Configuration – Configuration of the link control protocol.
State – State of the IP link (Initial, Opened, Closed).
IP Address – IP address assigned to this end of the link.
November 1997
B-D-H (A)
B-D-H (B)
B-D-H (C)
8000-A2-GB20-20