Removing The Front Panel; Mounting The Front Panel - Carel heaterSteam User Manual

ENG

1.6 Removing the front panel

Models UR002...UR013:
1
2
1.
turn the oval plate with the CAREL logo until the ground screw head
can be seen;
2. loosen the screw with a screwdriver;
3. grab the sides of the panel, lift it about 20 mm (0.79 in), and detach it
from the protruding edges of the humidifi er;
4.
remove the panel by pulling it forward;
5. remove the protective fi lm.
Models UR020...UR080:
1
1. remove the screws on the top of the humidifi er using a screwdriver;
2.
grab the panel by lifting it from the top about 20 mm (0.79 in);
3.
remove the panel by pulling it forward;
4. remove the protective fi lm (on all external surfaces of the humidifi er).
"heaterSteam" +0300080EN - rel. 1.0 - 27.04.2016
5
3
4
Fig. 1.e
4
5
3
2
Fig. 1.f

1.7 Mounting the front panel

Models UR002...UR013:
1
3
2
1.
turn the red oval plate with the CAREL logo so that the fastening hole
below is visible;
2.
slide the panel on the frame (keeping it slightly raised and tilted) until
it stops on the rear edges;
3.
fasten the ground screw using a screwdriver, ensuring its tightening;
4. turn the red oval plate with the CAREL logo so that the fastening hole
below is no longer visible;
Models UR020...UR080:
2
1
1.
slide the panel on the base, keeping it slightly tilted;
2. put it in vertical position and tighten the screws on the top cover
with a screwdriver.
Caution: in models UR020...UR080 open the electrical
compartment of the humidifi er using the slotted lock.
8
4
Fig. 1.g
Fig. 1.h
Fig. 1.i