Installing A Power Module Or Power Bay Cover - HP StorageWorks M2402 User Manual

Installing a Power Module or Power Bay Cover

To install a power module or power bay cover:
1. If a power module or power bay cover has not been removed, refer to the
2. Remove the new power module from its shipping container and remove all
3. To install a power module, hold the handle 2 shown in
4. Tighten the thumbscrews on the power module or power bay cover.
Network Storage Router M2402 User Guide
preceding procedure, "Removing a Power Module or Power Bay Cover."
When completed, proceed to Step 2.
packing material from around the module (see
Caution: Place the module onto a smooth surface and avoid exposure to
direct sunlight, liquids or vapors, excessive heat, risk of accidental dropping,
or other damage.
bottom plate of the module beneath the guides of the bay opening, and slide
the module into the power bay until the outer plate of the module is flush
against the front of the router.
Caution: When installing a module, ensure the edges of the bottom plate of
the module are beneath the guides of the bay opening. Failure to properly
install a module may result in damage to the module or router and may void
your service warranty.
To install a power bay cover, carefully slide the cover so that it clips onto the
left side of the power bay. Verify the orientation of the warning message as
seen in Figure 113.
Hardware Module Replacement
Figure 112).
Figure 112, align the
191