HP StorageWorks M2402 User Manual page 127

Network Storage Router M2402 User Guide
Change Map Settings (6) changes and displays map settings for the module.
Mapping modes can be Auto-Assigned, Indexed (default), or SCC.
For more information about addressing methods, see
"Addressing Methods and Table Structures."
Because the procedures for editing maps are the same for Fibre Channel and
SCSI modules, they are documented only one time. See "Device Mapping"
later in this chapter for procedural instructions on the following mapping
tasks:
— Viewing the Current Map
— Creating a New Map
— Removing the Current Map
— Editing the Current Map
— Cloning a Map
— Editing the Host List for the Current Map
— Viewing the Entire Device List
Change Override Settings (7) lets you enter Fibre Channel override settings.
Caution: If these configuration settings are incorrectly set, processing
difficulties may occur. Before changing these settings, evaluate the need for
the change and verify the desired setting. HP recommends backing up the
router configuration to an external file before making changes to this setting.
A sub-screen is displayed, listing the following options:
— Toggle Hi-Sup Bit Settings (1) changes the Hi-Sup Bit settings. Options
include Set and Clear.
— Toggle Forcing FCP Response Code (2) For HBA #223180-B21 and
#120186-001 changes the forcing of the FCP response code. Options
include Off and On.
— Toggle Initiator Bit Setting in PRLI_ACC (3) changes the Initiator bit
setting. Options include Set and Clear.
If the router is deployed in a router-to-router configuration where at least
one router appears as target and another as initiator, set this option to Set.
Serial/Telnet User Interface
Appendix C,
133