Removing An I/O Module Or Blank Module - HP StorageWorks M2402 User Manual

Removing an I/O Module or Blank Module

To remove an I/O module:
1. Remove power to the router.
2. Loosen the thumbscrews 1 on the I/O module or blank module shown in
Figure 117: Thumbscrews and handle on an I/O module or blank module
3. Holding the handle 2 shown in
Network Storage Router M2402 User Guide
Caution: I/O modules or blank modules must be installed in each I/O bay to
ensure proper cooling. If proper cooling is not maintained, the router could
overheat and automatically power off.
Figure 117 in a counterclockwise rotation.
The thumbscrews cannot be physically detached from the modules, but can be
loosened so that the I/O module or blank module can be removed.
module until it has completely cleared the I/O bay.
Caution: I/O bays must either have an I/O module or I/O module blank
installed to ensure proper cooling. If proper cooling is not maintained, the
router could overheat and automatically power off.
Hardware Module Replacement
1
2
Figure 117, pull out the I/O module or blank
195